Where should you check first when an excavator veers while traveling?
Nov 16, 2026

When an excavator veers while traveling, first drive straight at low speed on flat, firm, safe ground to confirm the direction of the deviation. Then check the tension of both tracks and the travel resistance. Soil buildup, tracks that are too tight, or binding undercarriage components can all slow one side. Do not diagnose a hydraulic pump or travel motor failure based on veering alone.

First check track tension and undercarriage resistance

Shut down the machine and lower the attachment to the ground. Remove mud and stones from around the track frames, sprockets, and idlers, and check for wedged debris. Heavy clay buildup can cause different levels of resistance on the two sides. After cleaning, drive straight again and see whether the veering has decreased.

Measure track sag according to the maintenance manual for the specific machine model, and adjust it using the specified procedure. Track sag must be assessed based on the measurement location, whether the track is off the ground, and the undercarriage configuration; do not estimate it from appearance alone. Tracks that are too tight increase rolling resistance and accelerate wear on pins, bushings, and track rollers. Tracks that are too loose may mesh improperly or come off. When adjusting the track tensioner, follow the manual's pressure-release procedure to prevent high-pressure grease from spraying out.

Next, check the track rollers, carrier rollers, and idlers for oil leaks, uneven wear, or binding, and check whether any track links are stiff. If one side shows obvious wear or abnormal rotation, address the mechanical resistance first, then retest the machine's travel performance.

Distinguish operating conditions from hydraulic faults

On the same flat surface, test the machine traveling forward and in reverse. Record the direction and speed of the veering, and whether it occurs only in a particular travel speed range. Slope, ground firmness, and differences in track tread wear can all affect the machine's path, so keep the surface and operating conditions as consistent as possible during comparisons. The location of the travel motors on the machine can also change the apparent direction of travel, so record observations by the machine's left and right sides.

After ruling out mechanical resistance, check for abnormalities in the travel control signals, related valve assemblies, and lines. If one side is clearly weak both forward and in reverse, further test the pressure, flow, and motor case drain of that side's travel circuit in accordance with the service manual. If the problem occurs in only one direction, also check the controls and valve assembly for that direction. Interpret pressure readings in the context of the test conditions; a single static reading cannot identify the faulty component.

Before testing pressure or flow, shut down the machine and release any residual system pressure. Confirm that the fittings and test instruments meet the manual's requirements. After testing, restore the lines as specified and retest straight-line travel in a safe area.

Previous:No more content