| News News
When converting to an extended-reach arm, the base machine’s tonnage directly affects operating stability and load capacity, but bigger is not always better. Before choosing, determine the maximum working radius, digging depth, material properties, and attachment configuration. Then verify the machine’s load capacity and structural strength in the actual operating positions.
On the same excavator, the farther the bucket reaches, the greater the overturning moment on the machine is generally likely to be. Although applications such as dredging and slope trimming may not require a large bucket, long-reach operations place greater demands on stability. If digging in harder soil is also required, the impact loads on the boom and its connection points must also be taken into account.
When evaluating the machine, do not rely solely on the original rated bucket capacity or operating weight. Obtain load data for the proposed conversion and check the allowable loads at the maximum radius and in different working directions. The load chart for the original standard boom cannot be used directly as a basis for an extended-reach arm. The bucket, couplings, and material weight must also be included in the calculations for the proposed configuration.
Adding counterweight may improve stability in some operating positions, but it also increases the load on the undercarriage, swing bearing, and related structures, while changing transport weight and rear swing clearance. Where access is restricted or the ground is soft, simply adding counterweight may not be the best option.
Also check the strength and fatigue risks of the boom foot, pins, cylinder connection points, and boom itself, and confirm that the hydraulic system can meet the operating requirements. For conversions of older machines in particular, inspect welds, pin-hole wear, and existing cracks. Machines with the same rated tonnage can still differ in their actual serviceable condition.
If the target machine has insufficient capacity margin at the maximum working radius, consider using a smaller bucket, shortening the arm, or choosing a higher-tonnage base machine rather than relying solely on experience to add counterweight. Before finalizing the configuration, ask the conversion provider for complete configuration, load, and structural verification documentation, and reassess the setup against the site’s ground conditions and operating methods.