| News News
A hydraulic pump losing power when hot commonly shows normal operation when cold, followed by slower movement and reduced power under load as the oil temperature rises. As the oil thins with heat, internal leakage increases. If the pump or valves are worn, performance loss when hot may be more pronounced. However, the cause may also be the relief valve, an actuator, or the cooling system. Do not replace the hydraulic pump based solely on the symptom “it loses power when hot.”
Oil viscosity decreases as temperature rises. If the oil temperature exceeds the equipment’s permitted range, or the oil grade does not meet requirements, leakage through the pump’s internal clearances increases, reducing output flow and slowing the actuators. This may be more pronounced when the pump’s friction surfaces are worn.
Internal leakage also converts some hydraulic energy into heat, pushing the oil temperature higher and creating a cycle of rising temperature, increased leakage, and reduced power. Therefore, temporary recovery after cooling does not mean the fault has been resolved.
Under the same speed, load, and operating conditions, record the oil temperature, system pressure, and actuator behavior when cold and when the fault occurs at operating temperature. Slower movement indicates insufficient effective flow. If the equipment lacks power under load and pressure fails to reach the specified value, check the pump, pressure control valve, and actuators. Slow movement and insufficient pressure may also occur at the same time.
If conditions permit, use suitable flow and pressure testing equipment in accordance with the equipment service manual. Compare output flow when cold and hot at the same speed and test pressure. A marked drop in hot-state flow provides grounds for further investigating internal pump leakage. For variable-displacement pumps, also check the displacement control mechanism and its control pressure to avoid mistaking a control fault for pump wear.
A sticking relief valve spool, poor valve-seat sealing, or abnormal control pressure can divert some flow back to the tank and generate heat. Leaking cylinder piston seals and wear in hydraulic motors can also cause loss of power when hot. Use the circuit diagram to check the relevant return or case-drain flow, but assess the results against the equipment’s specified values. Temperature rise or return flow alone is not enough to identify a faulty component.
Also check the oil level and condition, the cooler, and the cooling fan or water circuit to confirm that cooling is working properly. A clogged suction strainer or air entering the suction line can also cause noise, insufficient oil supply, and overheating. If abnormal oil temperature is caused by continuous relief flow through a valve or excessive mechanical load, cleaning the cooler alone will not eliminate the heat source.
Before servicing, shut down the equipment, release system pressure, and secure any components that could fall. Hot oil and high-pressure fluid injection can cause injury. Perform pressure testing, loading, and disassembly in accordance with the equipment service manual. Do not compensate for loss of power by blindly increasing the relief valve pressure, as this may damage the pump and actuators.